How to improve the production efficiency of hydraulic water well drilling rigs?The following editor will talk about the precautions for using it.
1.After the drill bit of the hydraulic water well drilling rig is drilled into the structure,the center drilling tool needs to be replaced in time.First,you need to clean the bottom of the hole,and then blow off the residue at the bottom of the hole.After the drill bit stops rotating,the drill bit in the hydraulic water well drilling rig is drilled out.It is most suitable when the lifting force increases slowly and the lifting force is just enough to lift the drill.
2.The drilling process summarizes the drill bit of the hydraulic water well drilling rig.It is also necessary to pay close attention to the subsequent working conditions of the casing,to understand the specific situation of the drilling in time,to clean the drilling in time,and to drill the bit on the water well drilling rig.During this process,strong lifting is prohibited.
3.There will be more residues at the bottom of the hydraulic water well drilling rig.The eccentric drill bit will be stuck by the slag and affect its collection and production.At this time,it is necessary to deliver compressed air and clean the holes again.And let the down-the-hole hammer work for a short period of time,the water well drilling rig model,and then re-do the lifting work of the center drill.
Hydraulic water well drilling rig working system and matters needing attention
Since the movement system of the pocket machine is different from any operating state and operating characteristics of each device,it is divided into three parts,the rotation system,the circulation system and the circulation system.And,in this way,it is completely configured as a system.
Rotating equipment and tools.
Circulatory system equipment and tools.
System equipment and tools.
Power drive system equipment.
Mobile system equipment.
Control the system and check the display list.
The following items usually mean that they are installed after installation and installed afterwards.
(1)The open gas,liquid and water pipes are sealed accordingly,and the inside of the channel and the joints are kept clean to prevent foreign matter from entering.
(2)When removing the fastener,please clamp the clip,affix a label or put it in a special box.
(3)Separately packaged spirals and spirals are packaged separately to avoid mixing high-strength spirals,other spirals and spirals.
(4)The software of the air system degreasing,the problem of the water well drilling rig,clean the plastic packaging by tightening the outside of each pipe,scratch the screws and keep the inside of the pipe clean.
(5)Be careful not to damage the machine when disassembling or hanging.
(6)When placed in a remote place or stored for a long time,it is not exposed to rain,moisturizing,anti-fouling,ready for packaging,and ready for packaging and packaging.
(7)All liquids(oil,water)in the equipment are used to dry the discharge.
What are the steps to install a hydraulic water well drilling rig?
1.First of all,make sure that the installation of the water well drilling rig should be carried out by a skilled operator,and one person is responsible for the order.
2.Secondly,before determining the installation of the water well drilling rig,the topography,geology,hydrology,weather and flood level should be investigated.
3.According to the water well drilling rig at the horizontal site,the installation needs to install the drilling rig base,tower,ground anchor,etc.
4.Flatten a solid part next to the predetermined orifice,the area should not be less than 53.3m2,the front of the wellhead may be uneven,but there should be no obstacles above 1m.
5.When the hydraulic water well drilling rig is equipped with a ground beam,the diesel engine transmission device and the hoist are fixed on the base of the drilling rig.